Your vehicle may be equipped with the Cargo Camera that allows you to see an image of the inside of the pickup box. The image will be displayed in the Uconnect screen.
The Cargo Camera is located in the bottom center area of the Center High Mounted Stop Lamp (CHMSL).
A touchscreen button to indicate the current
active camera image being displayed is made available whenever the
Cargo Camera image is displayed.
A touchscreen button to switch the display
to rear view camera image is made available whenever the Cargo Camera
image is displayed.
A touchscreen X button to disable display of the camera image is made available when the vehicle is not in REVERSE gear.
A display timer is initiated when the Cargo Camera image is displayed. The image will continue to be displayed until the display timer exceeds 10 seconds and the vehicle speed is above 8 mph (13 km/h) or the touchscreen X button to disable display of the Cargo Camera image is pressed.
Cargo Camera With Dynamic Centerline (Available With Surround View Camera Only) — If Equipped
The Dynamic Centerline feature provides an overlay on the Cargo Camera display screen that aligns to the center of the pickup box to aid in hooking up a fifth wheel camper or gooseneck trailer. The centerline auto aligns to the center of the pickup box, and can also be manually adjusted. The centerline will adjust in response to steering angle inputs, and will not obstruct the gooseneck receiver or an approaching trailer gooseneck in the camera feed.
Activation
The Dynamic Centerline feature can be activated through the Uconnect Settings by pressing the Cargo Camera button, followed by the Adjust Centerline button on the touchscreen.
If the Dynamic Centerline feature is turned on, the overlay will display anytime the Cargo Camera image is displayed.
Adjusting Centerline
Refer to the following steps to manually adjust the centerline:
-
Press the Adjust Centerline button located in the bottom right corner of the Cargo Camera display.
-
Use the arrows on the bottom left corner of the Cargo Camera display to adjust the centerline horizontally or vertically.
-
Once the desired position is achieved, press the Accept button to set the centerline to the newly specified position.
Deactivation
The Dynamic Centerline feature will automatically be deactivated whenever the Cargo Camera display is deactivated. It can also be manually deactivated through the Uconnect Settings UCONNECT SETTINGS.
-
If the vehicle speed remains below 8 mph (13 km/h), the Cargo Camera image will be displayed continuously until the touchscreen X button to disable display of the Cargo Camera image is pressed.
-
The touchscreen X button to disable the display of the camera image is made available ONLY when the vehicle is not in reverse.
-
If snow, ice, mud, or any foreign substance builds up on the camera lens, clean the lens, rinse with water, and dry with a soft cloth. Do not cover the lens.