Rear Tail/Stop, Turn Signal And Backup Lamps

See the following steps to replace:

1. Remove the two screws and pushpins that pass through the bed sheet metal.

   

   Tail Lamp Locations

   1 — Tail Lamp
   2 — Screws
   3 — Fasteners

2. Pull the outboard side of the lamp rearward far enough to unsnap the two receptacles on the outboard side of the lamp housing from the two plastic snap post retainers in the outer box side panel.

   

   Tail Lamp Removed

3. Disconnect the wiring harness connectors from the bulb socket.

4. Rotate the bulb socket counterclockwise a quarter turn to unlock it from the housing.

5. Pull the bulb straight out of the socket.

   CAUTION!:

   Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.

6. Reverse the procedure to install the bulb and housing.