When shifting into or out of 4WD LOW some gear noise may be heard. This noise is normal and is not detrimental to the vehicle or occupants.
Shifting can be performed with the vehicle rolling 2 to 3 mph (3 to 5 km/h) or completely stopped. You can use either of the following procedures:
Preferred Procedure
With the engine running, slow the vehicle to 2 to 3 mph (3 to 5 km/h).
Shift the transmission into NEUTRAL.
While still rolling, push the desired position on the transfer case control switch.
After the desired position indicator light is on (not flashing), shift the transmission back into gear.
Alternate Procedure
Bring the vehicle to a complete stop.
With the ignition switch in the ON/RUN position and the engine running, shift the transmission into NEUTRAL.
Push the desired position on the transfer case control switch.
After the desired position indicator light is on (not flashing), shift the transmission back into gear.
If Steps 1 or 2 of either the Preferred or Alternate Procedure are not satisfied prior to attempting the shift, then the desired position indicator light will flash continuously while the original position indicator light is on, until all requirements have been met.
The ignition switch must be in the ON/RUN position for a shift to take place and for the position indicator lights to be operable. If the ignition switch is not in the ON/RUN position, the shift will not take place and no position indicator lights will be on or flashing.