Use of traction devices require sufficient tire-to-body clearance. Due to limited clearance, the following snow traction devices are recommended. Follow these recommendations to guard against damage:
Snow traction device must be of proper size for the tire, as recommended by the snow traction device manufacturer.
No other tire sizes are recommended for use with the snow traction device.
Please see the following table for the recommended tire size, axle and snow traction device:
|
2500 4x2 (2WD) Trim Level |
Axle |
Tire/Wheel Size |
Snow Traction Device (Maximum Projection Beyond Tire Profile Or Equivalent) |
|---|---|---|---|
|
Tradesman |
Rear |
LT245/70R17E LT275/70R18E |
U Class |
|
Bighorn Laramie Longhorn |
LT275/70R18E LT285/60R20E |
||
|
Limited |
LT285/60R20E |
|
2500 4x4 (4WD) Trim Level |
Axle |
Tire/Wheel Size |
Snow Traction Device (Maximum Projection Beyond Tire Profile Or Equivalent) |
|---|---|---|---|
|
Tradesman |
Rear |
LT245/70R17E LT285/70R17D LT275/70R18E |
U Class |
|
Bighorn Laramie Limited Longhorn |
LT275/70R18E LT285/60R20E |
||
|
Power Wagon |
LT285/70R17D LT275/70R18E LT285/60R20E |
|
3500 SRW 4x2 (2WD) & 4x4 (4WD) Trim Level |
Axle |
Tire/Wheel Size |
Snow Traction Device (Maximum Projection Beyond Tire Profile Or Equivalent) |
|---|---|---|---|
|
Tradesman |
Rear |
LT275/70R18E |
U Class |
|
Bighorn Limited Laramie Longhorn |
LT275/70R18E LT285/60R20E |
|
3500 DRW 4x2 (2WD) Trim Level |
Axle |
Tire/Wheel Size |
Snow Traction Device (Maximum Projection Beyond Tire Profile Or Equivalent) |
|---|---|---|---|
|
Tradesman Bighorn |
Rear |
LT235/80R17E |
U Class |
|
Limited Laramie Longhorn |
Front/Rear |
LT235/80R17E |
U Class |
|
3500 DRW 4x4 (4WD) Trim Level |
Axle |
Tire/Wheel Size |
Snow Traction Device (Maximum Projection Beyond Tire Profile Or Equivalent) |
|---|---|---|---|
|
Tradesman Bighorn Limited Laramie Longhorn |
Front/Rear |
LT235/80R17E |
U Class |
Using tires of different size and type (M+S, Snow) between front and rear axles can cause unpredictable handling. You could lose control and have a collision.
To avoid damage to your vehicle or tires, observe the following precautions:
Because of restricted traction device clearance between tires and other suspension components, it is important that only traction devices in good condition are used. Broken devices can cause serious damage. Stop the vehicle immediately if noise occurs that could indicate device breakage. Remove the damaged parts of the device before further use.
Install device as tightly as possible and then retighten after driving about ½ mile (0.8 km). Autosock traction devices do not require retightening.
Do not exceed 30 mph (48 km/h).
Drive cautiously and avoid severe turns and large bumps, especially with a loaded vehicle.
Do not drive for a prolonged period on dry pavement.
Observe the traction device manufacturer’s instructions on the method of installation, operating speed, and conditions for use. Always use the suggested operating speed of the device manufacturer’s if it is less than 30 mph (48 km/h).
Do not use traction devices on a compact spare tire.