Tri-Fold Tonneau Cover Installation

To install the Tonneau Cover follow these steps:

1. Position the folded Tonneau Cover on the truck bed and push the cover forward against the front of the truck bed. The Tonneau Cover centers itself when placed on the vehicle.

   Note:

   Make sure to always push the Tonneau Cover all the way forward on the truck bed. Failure to do so might prevent proper clamp engagement, or interfere with the electronic tailgate release function (if equipped).

   

   Location Of Front Latches

2. Pull down on the first set of clamp handles to release the clamps from the Stowed Position.

   

   Stowed Position

3. Push clamp wires up and under the flange of the box (or flange of the RamBox rail, if equipped) to the Semi-Clamped Position.

   

   Semi Clamped Position

4. Push clamp handles upward to the clamped position to properly engage the clamps.

   

   Clamped Position

   Note:

   Once clamped, be sure the clamps are not improperly attached to the truck bed flange.

   

   Improper Clamp Position

5. Disengage the stowage straps.

6. Unfold the center and rear panels to the Intermediate Position.

   

   Intermediate Position (Vehicle Cannot Be Driven)

   Note:

   When folding the center and rear panels, the sections MUST be held together to avoid damage to the cover material.

   

   Incorrect Folding — Will Cause Damage

   

   Correct Folding — Hold Panels Together

7. Completely unfold the Tonneau Cover.

   

   Fully Unfolded Position

8. Pull the rear clamp handles down into the Released Position.

   

   Stowed Position

9. Push clamp wires up and under the flange of box (or flange of RamBox rail, if equipped) to the Semi Clamped Position.

   

   Semi Clamped Position

10. Push clamp handles upward to the clamped position to properly engage the clamps.

    

    Clamped Position

    

    Improper Clamp Position

    Note:

    Once clamped, be sure the clamps are not partially clamped to the truck bed flange.

The Tonneau Cover clamps can be locked when in the clamped position by placing a lock through the locking hole.