Base Quad: Low Beam Headlamp, High Beam Headlamp, Front Park And Turn — If Equipped

Low Beam

See the following steps to replace:

  1. Open the hood.

  2. Disconnect and isolate the negative battery cable.

  3. Reach into the front wheel house ahead of the front wheel, remove the fastener, and lift the cover over the access hole in the front of the wheel house splash shield. Access to the rear of the lamp can be gained through this access hole.

    Splash Shield Access Cover

  4. Reach through the access hole of the wheel house splash shield and disengage the bulb access cover by rotating counterclockwise.

    Bulb Access Cover

  5. Disconnect the internal lamp wiring harness connector from the low beam bulb.

    CAUTION!:

    • Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.

    • Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the bulb socket, or the lamp wiring.

  6. Rotate the bulb counterclockwise a quarter turn to unlock the bulb from the lamp.

  7. Pull the bulb straight out from the housing.

  8. Reverse the procedure for installation of new bulb and covers.

High Beam

See the following steps to replace:

  1. Open the hood.

  2. Disconnect and isolate the negative battery cable.

    Bulb Access Cover

  3. Look under the hood and behind the headlamp to find the high beam bulb access cover.

  4. Reach behind the headlamp and disengage the access cover by rotating counterclockwise.

  5. Disconnect the internal lamp wiring harness connector from the high beam bulb.

    CAUTION!:

    • Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.

    • Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the bulb socket, or the lamp wiring.

  6. Rotate the bulb counterclockwise a quarter turn to unlock the bulb from the lamp.

  7. Pull the bulb straight out from the housing.

  8. Reverse the procedure for installation of new bulb and covers.

Outer Front Park And Turn

See the following steps to replace:

  1. Open the hood.

  2. Disconnect and isolate the negative battery cable.

  3. Reach into the front wheel house ahead of the front wheel, remove the fastener, and lift the cover over the access hole in the front of the wheel house splash shield. Access to the rear of the lamp can be gained through this access hole.

    Splash Shield Access Cover

  4. Reach through the access hole of the wheel house splash shield and disengage the side marker socket by rotating counterclockwise a quarter turn.

    Park And Turn Sockets

  5. Pull the socket and bulb straight out from the housing.

  6. Separate the bulb from the socket without twisting.

  7. Reverse the procedure for installation of new bulb and covers.

Parent topic: Replacing Exterior Bulbs